Unpacking Instruction; Power Supply; Controls And Connections - Fenton FT12JB Bedienungsanleitung

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.

CONTROLS AND CONNECTIONS

1. MEDIAPLAYER CONTROLS
MP3/AUX/BT-MODE
Press key to switch between MP3 player, Aux
input or BT.
Press and hold key to switch voice off/on.
RECORD
Press key for recording on USB/SD port.
REPEAT
Press key for repeating of single track or all
tracks.
Press and hold key to switch off/on Auto-talk-
over.
PREVIOUS TRACK / VOL-
Press key to select the previous track for
playing. The volume will be reduced by
pressing the key for longer than 3seconds.
PLAY/PAUSE
Press key to switch between pause or playing.
NEXT TRACK / VOL-
Press key to select the next track for playing.
The volume will be increased by pressing the
key for longer than 3 seconds.
2. GUITAR INPUT
6.3mm ¼" input jack for connecting a guitar.
3. GUITAR VOLUME
Adjust the signal level of the guitar input.
4. RCA LINE INPUT
RCA jack input for connecting audio units with
line level output (e.g. mixer, CD player, tape
recorder).
5. MICROPHONE INPUT
6.3mm ¼" input jack for connecting a microphone.
6. USB PORT
Connect your USB devices to this slot to play music with MP3 or WMA format.
7. SD PORT
Connect your SD/MMC card in this slot to play music with MP3 or WMA format.
8. ECHO CONTROL
Adjust the intensity of the echo effect.
9. MICROPHONE VOLUME
Adjust the signal level of microphone.
10. BASS
Adjust high low tone control.
11. TREBLE
Adjust high tone control.
12. MASTER VOLUME AND ON/OFF
Adjust the overall output level of the portable sound system.
13. LIGHT SWITCH
Turn on the LED (frontside) and jellyball of the speaker on/off.
14. POWER INPUT
Before connecting the power cord, check if the mains corresponds to the voltage indicated on the rating plate on the
unit.
4