Unpacking Instruction; Power Supply; Controls And Connections; Replacing The Fuse - Fenton FT Serie Bedienungsanleitung

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.

CONTROLS AND CONNECTIONS

1. Mediaplayer
Play music from an SD,USB memory device or
BT.
2. Guitar volume
Adjust the signal level of guitar.
3. Echo
Adjust the intensity of the echo effect.
4. Microphone Volume
Adjust the signal level of microphone.
5. Bass
Adjust high low tone control.
6. Treble
Adjust high tone control.
7. Volume
Adjust the overall output level of the portable
sound set.
8. Guitar Input
6.3mm ¼" input jack for connecting a guitar.
9. Microphone input
6.3mm ¼" input jack for connecting a
microphone.
10. Aux In
3.5mm input jack for connecting a mobile phone.
11. Aux In-/ Output
RCA jack in-/output for connecting audio units with line level output (e.g.
mixer, CD player, tape recorder).
12. LED Switch
Turn on the LED (frontside) of the speaker
on/off
13. Power switch
Turn the power on/off
14. Power input
Before connecting the power cord, check if the mains corresponds to the voltage indicated on the rating plate on the
unit.

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
3