Unpacking Instruction; Power Supply - Fenton VSB40 Bedienungsanleitung

UNPACKING INSTRUCTION

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
GENERAL
Bass knob
1.
Treble knob
2.
Volume knob
3.
Input for 3.5mm stereo plug
4.
BT LED
5.
Power switch
6.
USING WITH YOUR DEVICES
There are two ways to connect your phone, tablet, laptop to your loudspeaker, whether using a physical cord or via wireless BT.
Below you will find more details about the connection sources, in two categories:
• wireless connection via BT
• connection via the 3.5mm stereo plug
CAUTION! Make sure that the volume is set to low on both the Jukebox and the music player when you start playing music.
CONNECTING VIA BT
With the help of BT technology, BT-compatible devices can easily be connected to each other over a short Wireless connection.
Use your BT-enabled smartphone, tablet or computer to stream music directly to your active speaker. Follow these steps to
connect your speaker wirelessly to your BT device.
Instuction for VBS40:
1. Turn the active loudspeaker on. The BT led will blink red and blue intermittently.
2. Activate the BT functionality on your device (smartphone, tablet, computer).
3. On your device, select the VSB speaker from your list. When successful: every couple of seconds, the led will blink
blue twice in quick succession.
4. You are now ready to play your tunes wirelessly! When playing, the led will turn red and blink blue once every few
seconds.
Instuction for VBS80:
1. Turn the active loudspeaker on. The BT led will blink blue intermittently.
2. Activate the BT functionality on your device (smartphone, tablet, computer).
3. On your device, select the VSB speaker from your list. When successful: the led will be blue continuously.
4. You are now ready to play your tunes wirelessly! When playing, the led will blink blue once every few seconds
CONNECTING SOURCES BY CABLE
There is another way to connect to your active speaker, the old fashioned way,
using a cord and the 3.5mm input. Use a double-ended coil cord with 3.5mm
plugs to connect to audio sources that have audio output such as a mobile
phone, mp3 player, etc.
4