Setting Mode - ZANKER ZKVS1530 Benutzerinformation

Setting mode

The appliance is in setting mode when all
programme lights are off and End of pro-
gramme light flashes.
IMPORTANT!
Always remember that when performing oper-
ations such as:
• selecting a washing programme
• setting the water softener
• deactivation/activation of the audible signals
Programme selection/RESET button
78
the appliance MUST be in setting mode.
If a programme light is illuminated and End of
programme light is illuminated with fixed light,
the last performed programme is still set.
In this case the programme has to be cancelled:
1. Press and hold the Programme selection/
RESET button until the light of the running
programme turns off and the End of pro-
gramme light is flashing.
2. Release the Programme selection/RE-
SET button.
• Starting the washing programme:
1. Press the On/Off button.
2. Press the Programme selection/RESET button
once, the light of the last performed washing pro-
gramme illuminates and the End of programme
light flashes.
3. Press the Programme selection/RESET button
as many times as necessary to illuminate the light
corresponding to the desired programme.
4. Close the dishwasher's door, the programme will
start automatically.
IMPORTANT!
Once the programme has started, if you want to
change the selection made you must cancel the wash-
ing programme in progress.
• Cancel the washing programme in progress:
1. Open the door.
2. Press and hold the Programme selection/RE-
SET button until the light of the running pro-
gramme turns off and the End of programme light
is flashing.
3. Release the Programme selection/RESET but-
ton.
4. Switch off the machine by pressing the On/Off
button or select a new washing programme (check
that there is detergent in the detergent dispenser).