Drain Hose - ZANKER ZKVS1530 Benutzerinformation

If the water inlet hose leaks, the safety valve
cuts off the water supply.
WARNING!
The electrical cable for the safety valve is in the
double-walled water inlet hose and is live.

Drain hose

Connect drain hose to the
sink.
CAUTION!
To avoid water leakage after installation make
sure that the water couplings are tight.
The waste connection
must be at a maximum 60
cm from the bottom of the
dishwasher.
Therefore do not immerse the water inlet hose
or the safety valve in water.
Take care when installing the water inlet hose
. Place the water inlet hose in such a way that
it is always lower than the bottom edge of the
safety valve.
If the water inlet hose or the safety valve is
damaged, remove the mains plug immediately.
CAUTION!
A water inlet hose with safety valve MUST only
be replaced by your local Service Force Centre.
Ensure that the hoses are
not kinked, crushed or en-
tangled. The internal di-
ameter of the couplings
used for connections to
the waste outlet must be
no smaller than the diam-
eter of the hose provided.
When connecting the
drain hose to an under
sink trap spigot, the entire
plastic membrane (A)
must be removed. Fail-
ure to remove all the mem-
brane will result in food
particles building up over
time eventually blocking
the dishwasher drain hose
spigot.
95