Setting The Water Softener; Manual Adjustment; Electronic Adjustment - ZANKER ZKI1410 Benutzerinformation

5. Set the correct washing programme for the type of
load and soil.
6. Fill the detergent dispenser with the correct quan-
tity of detergent.

Setting the water softener

The water softener removes minerals and salts from
the water supply. Minerals and salts can have bad ef-
fect on the operation of the appliance.
Water hardness is measured in equivalent scales:
• German degrees (dH°).
• French degrees (°TH).
°dH °TH
51 - 70 91 - 125
43 - 50 76 - 90
37 - 42 65 - 75
29 - 36 51 - 64
23 - 28 40 - 50
19 - 22 33 - 39
15 - 18 26 - 32
11 - 14 19 - 25
4 - 10 7 - 18
< 4 < 7
1) No use of salt required.
You must set the water softener manually and
electronically.

Manual adjustment

The appliance is set at the factory at position 2.
20
Water hardness
mmol/l
9,1 - 12,5
7,6 - 9,0
6,5 - 7,5
5,1 - 6,4
4,0 - 5,0
3,3 - 3,9
2,6 - 3,2
1,9 - 2,5
0,7 - 1,8
< 0,7
7. Start the washing programme.
If you use detergent tablets, refer to the chapter
'Use of detergent'.
• mmol/l (millimol per litre - international unit for the
hardness of water).
• Clarke.
Adjust the water softener to the water hardness in your
area. If necessary, contact your local water authority.
Clarke manually
64 - 88 2
53 - 63 2
46 - 52 2
36 - 45 2
28 - 35 2
23 - 27 2
18 - 22 1
13 - 17 1
5 - 12 1
< 5 1)
1
1

Electronic adjustment

The water softener is set at the factory at level 5.
Water hardness setting
electronically
10
9
8
7
6
5
4
3
2
1)
1
2
Set switch to position 1 or
2.