Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mains voltage - Fuses
Check that the equipment
voltage, see figure.
230 V, 50 Hz:
The equipment
is set to 230 V, 50 Hz at the
factory
and is fitted with a 4 A fuse for this
operating voltage.
115 V, 60 Hz:
• Set the voltage selector on the equ ipment to
the 115 V position
(use a screwdriver).
• Change the fuse to 8 A (supplied).
fuse holder with a screwdriver.
Fuses:
230 V, 50 Hz: 4 A, slow blow, 5 x 20 mm.
115 V, 60 Hz: 8 A, slow blow, 5 x 20 mm.
Mains sockets (outlets) for extra
equipment
The sockets for extra equipment are only
permitted in the USA.
The socket marked Unswitched
to the supply voltage and is designed for
connecting
equipment
with a maximum
consumption
of 300 watts.
The socket marked Switched 300 W Max. is
controlled
by the mains switch on the equipment,
and is designed for connecting
maximum
total consumption
Electronic
circuits will protect the power
amplifier
against:
-
Load impedances lower than 2 ohms per
channel.
- Short circuit
in the speaker connections.
event a relay will pull in and out (making a
clicking sound).
- Protect the speakers from damage caused by
d.c. voltages.
Furthermore
a thermal fuse will operate if the
temperature
inside the amplifier
normal operating temperature.
reset automatically
when normal temperature
conditions
are resumed.
IMPORTANT!
When placing this power amplifier
in a rack or in a shelf, always be sure that
sufficient
ventilation
is available.
4
is set to the correct
Open the
300 W goes direct
total
equipment
with a
of 300 watts.
In this
rises above
This fuse will be
115V-8A
230V-4A
UDc;~~~ed~OF"" ' ~ D;~c::;~.
115V
+ ,~,
0
I..;L-,
115VTSA
D
i\;-J
""
T"
+
"0:' 0 %
0
230V
~~_CV50/60HZ600=W========
~~
60
,:,0
0'
,,0~w·t.;360j:1A
"
0
8
o
~-
(1160Hz
60C
=============
DOD
0
0
0 °0 -
e","ccc~'~I,oIlA"""'o,'
CAUTIONO
ATTENTION:
Sassu'er du voltage
I
VQRSICHT,
Achten S<", auf dIe ctChl'gE! Netzspannu
=======
Werbung
