Operations; Turning On/Off; Selecting The Pmr466 Or Ldp Band; Channel Selection - Midland G9 PLUS Bedienungsanleitung

Operations

Turning on/off

To turn on the transceiver, turn the VOLUME knob clockwise until you hear it
clicks. To turn off the transceiver, turn the knob counter-clockwise.

Selecting the PMR466 or LDP band

(only for the dual band version)
Midland G9 Plus (Dual band) is pre-set at factory on the PMR446 band.
To switch to the LPD band, keep pressed the MENU button until the LPD
shows channel '1'.
To return to the PMR446 band, keep pressed the MENU button again, until
the LCD shows 'P1'.
This procedure disables the "EMG" function; therefore if you change the fre-
quency band, remember to activate the Emergency function again (see paragraph
"Emergency function").

Channel selection

Press the MENU button. The number of the channel will start flashing on the
display.
Press the scroll buttons ▲▼ till you select the desired channel.
Press the PTT button to confirm, or wait for 5 seconds.
According to the version you bought, you can choose amongst the following
channels:
• Dual band version: PMR446 from P1 to P8 and from 9p to 24p (pre-set)
/ LPD from 1 to 69.
• E version (PMR446 only): from P1 to P8 and from 9p to 24p (pre-set)
Channel P8 has been set at factory for the "Emergency" function; we suggest
that you do not use it for general communications!

Displaying the channel/sub audio tone

To momentarily display the PMR446 channel and the subadio tone used in the
pre-set channels, go to the desired channel (from 9p to 24p) and keep pressed
the ▼ for 3 seconds.
12 | Midland G9/G9E Plus instruction guide