Bestway AquaDip Benutzerhandbuch Seite 3

AquaDip Pool Vacuum
Owner's Manual
Model No. #58339
Made in China
WARNING!
• THIS IS NOT A TOY!
• Do not let children use or play with this product.
• Do not allow swimming in the pool during pool vacuum operation.
• TURN OFF THE PUMP before connecting pool vacuum to the pool.
• If there are stones, roots or metal corrosion in contact with the
underside of the liner, clean them out before installing this product.
If necessary, have a qualified professional do the cleaning.
• If the liner is brittle, damaged or wrinkled, have a qualified
professional perform the necessary repairs or liner replacement
before installing this product.
• Make sure this product is not in the pool during any chemical
sanitization.
• Pump water flow varies for different pumps and filtration set up.
Under certain circumstances, the cleaner may climb the wall if
pump water flow is sufficient.
• TURN OFF THE PUMP before servicing this product or performing
any maintenance.
IMPORTANT! To operate properly, the pump should have
minimum power rating of 230W, and filtration
flow rate of 5,678 L/h (1,500gal/h).
TURN OFF THE PUMP ASSEMBLY
1 2
NOTE: Turn off the Place the mat "9" under the cleaner support "7" and make sure the fins are pointing upwards. Start by
pump before inserting the inner edge of the mat into the front groove of the foot pad "8". Stretch and insert the mat
assembly. all around the groove. The mat should be secured in the groove and free to rotate on the foot pad.
4
13
12 10 10
CONNECTION TO AGP
1
1
19
CONNECTION TO UNDER GROUND POOL
1
15
If your skimmer is equipped with dedicated suction line, insert the vacuum plug "15" into the vacuum hole first and then attach the pressure regulator "17" into the plug "15" by following the arrow marking
on pressure regulator bottom. Finally, attach the hose "12", canister and then balanced hose sections as instructed in "ASSEMBLY" section.
9
1. Screw cap
2. Chamber extension tube
3. Diaphragm chamber
4. Diaphragm connection tube
5. Retaining ring
Note: Drawings for illustration purpose only. May not reflect actual product. Not to scale.
9
9
12
22
10 11
2
17
12
15
22
2
18
12
19
17
22
17
8
4
5
6
19
22
6. Diaphragm
7. Main frame
8. Foot pad
9. Mat
10. Female-male hose
3
8
Insert the cuff on top of diaphragm chamber "2" into the end of hose "12"
as far as it can go. Insert one side of swivel connector "13" as shown into
the other end of hose "12" as far as it can go.
3
11
3
11
12 22
3
2
7
3
13
14
20 21
11. Female-female hose 16.
12. Short hose 17.
13. Swivel connector 18.
14. Hose weight 19.
15. Vacuum plug 20.
21.
22.
2
5
NOTE! AGP (WITH 2 WATER OUTLETS) –CLOSE ONE WATER OUTLET
11
1 15
16
17
12
11
10
18
Elbow
Pressure regulator
Strainer connection hose
Small hose connector
Medium hose connector
Hose connector base
Canister
13
12
NOTE:
The length of
hose should
longer than
the length of
the diagonal
of your pool.
10
S-S-005150