EuroLite PMC-16 MOVE Bedienungsanleitung Seite 46

Excursion:
A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master unit can start 3 different
Slave units, which run 3 different programs. The Master unit sends the 3 program parts in a continuous loop.
The Slave unit receives data from the Master unit according to the group which the Slave unit was assigned
to. If e.g. a Slave unit is set to „Slave 1" in the menu „Slave Set", the Master unit sends „Auto Program Part
1" to the Slave unit. If set to „Slave 2", the Slave unit receives „Auto Program Part 2".
To start a Auto Program please proceed as follows:
1.Slave-Setting
• Select "Function" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Slave Set" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Slave 1", "Slave 2" or "Slave 3".
• Press the Enter-button to confirm.
• Press the Mode-button in order to return to the main menu.
2. Automatic Program Run
• Select "Function" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Auto Program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Master" or "Alone". The selection "Alone" means Stand Alone-mode and
"Master" that the device is defined as master.
• Press the Enter-button to confirm.
• Press the Mode-button in order to return to the main menu.
3. Program selection for Auto Pro Part
• Select "Program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Select program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select "Pro Part 1", "Pro Part 2" or "Pro Part 3", and thus select which Slave
program is to be sent. Selection „Part 1" means, that the Slave unit runs the same program as the master
units.
• Press the Enter-button to confirm.
• Press the Mode-button in order to return to the main menu.
4. Program selection for Edit Program
• Select "Program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Edit program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select the desired program. With this function you can edit specific scenes into a
specific program.
• Press the Enter-button to confirm.
• Press the Mode-button in order to return to the main menu.
5. Automatic Scene Recording
• Select "Program" by pressing Up or Down.
• Press the Enter-button to confirm.
• Select "Edit scenes" by pressing Up or Down.
• Press the Enter-button to confirm.
• Press Up or Down to select the desired scene numbers. You can program a maximum number of 250
scenes.
• Press the Enter-button to confirm.
00092402.DOC, Version 1.1
46/55