Rf Installation With 6 Zones Master; Zone Rf Clock Installation - Tempco 51044 Bedienungsanleitung

3.3

RF Installation with 6 zones Master

To put you master in „RF init" mode, press 10 sec on
a)
the (OK) button. The first led blinks green. The LED
light up green for the zones already linked. Choose the
zone with the (◄) or (►) buttons. The selected zone
is indicated by the corresponding green blinking LED.
b) Press (OK), the zone can be linked with the desired
thermostat. You can select several zones. The LED (s)
of the selected channel (s) bright (s) red, indicating
that they are waiting for the signal from the thermostat.
The LED of the zones well linked bright green instead
of rot.
c) If you want to link other thermostats, repeat the step a
and b. To exit the „RF init" mode, press 10 sec. on the
(OK) button.
d) Setup menu of the thermostat see 3.4
e)
3.4

1 zone RF clock installation

You must enter in the installer menu by pressing the
a)
(◄-) and (►+) keys during 5s, then the following
screen must be displayed.
To exit the RF installation mode, press on the (
or press on the (OK) until "End" is displayed. Then, press
(OK).
(OK) 10 sec.
11
) button