Rf Installation; Rf Installation With One Zone Wall Receiver; Rf Installation With One Zone Flush Receiver - Tempco 51044 Bedienungsanleitung

3

RF installation

3.1

RF Installation with one zone wall receiver

First of all you must put the receiver in "RF init" mode.
a)
For this, press the Receiver push button during 5sec,
the Green RF LED should lit up (fixed) indicating that
the Receiver is now in radio configuration mode
waiting for a clock configuration address. (In all the
cases check the receiver leaflet for more explanation)
b) To link others one zone receiver, repeat the step a.
c) Setup menu of the thermostat see 3.4
3.2

RF Installation with one zone flush receiver

First of all you must put the receiver in "RF init" mode.
a)
For this, press the Receiver push button in the middle
of the receiver during 5sec, the Green RF LED should
lit up (fixed) indicating that the Receiver is now in radio
configuration mode waiting for a clock configuration
address. (In all the cases check the receiver leaflet for
more explanation)
b) To link others one zone receiver, repeat the step a.
c) Setup menu of the thermostat see 3.4
5 sec.
5 sec.
10