Explanation Of Symbols And Safety Instructions; Explanation Of Symbols; Requirements To Burner Installation Room; Instructions To Burner Installer - Sunsystem Burnit Pell series Technischer Datenblatt Montage- Und Bedienungsanleitung

1. EXPLANATION OF SYMBOLS AND SAFETY
EN

1.1. Explanation of symbols

CAUTION! - Important recommendation or
warning concerning safety conditions during
installation and operation of the pellet
burner
DANGER! - fault or improper use may cause
injury or be hazardous to life of humans or
animals.
FIRE HAZARD! - fault or improper installation
and operation may cause fire.
INFORMATION - Important information on
the proper operation of the product.
1.2. Requirements to pellet burner installation room
This manual contains important information for the
safe and correct installation, start-up and trouble-
free operation and maintenance of the pellet burner.
The pellet burner can be used for heating rooms only
in the manner described in this manual.
The application and any other was the area of
operation is not recommended by the manufacturer
and is not responsible for the occurrence of defects
or failures.
Note the pellet burner type data indicated on the
factory rating label and the technical data provided
in chapter 11 in order to ensure proper operation of
the product.
1.2.1. Instructions to boiler installer
During installation and operation, the country-
specific requirements and regulations must be
observed:
• local construction regulations on installation,
air supply and exhaust gas extraction as well as
chimney connection.
• regulations and norms concerning the fitting of the
heating installation with safety devices.
i
Use only original BURNiT parts
WARNING! Installation and setting the
pellet burner should be done by an

authorized specialist / service shop and
must follow the safety instructions and
rules of operation.

Customer must undergo boiler operation/
maintenance
installer/service shop.
TECHNICAL PASSPORT INSTALLATION and OPERATION MANUAL
INSTRUCTIONS
training by authorized
DANGER of intoxication, suffocation.
Inadequate inflow of fresh air to the boiler
room may result in dangerous leak of
exhaust gases during burner operation.
- Make sure the air inlets and exhaust gas

outlets are not clogged or closed.
- If faults are not remedied immediately, the
burner must not be operated
- The user must be provided with written
instructions on the fault and the hazard it
entails.
It is mandatory to assure a backup power

generator of corresponding rated power!
(see chapter 11.3)
DANGER of fire when burning flammable
materials or liquids.
- Flammable materials/liquids must not be
!
left in close proximity of the burner and
heating boiler.
- Instruct system user of the allowed
minimum clearances from surrounding
objects.
• Do not install the burner in sleeping premises.
• Do not connect the burner to any other air-intake
systems .
• The burner must be connected to the boiler as a
heating device
• Improper installation may cause fire or injury.
Contact your local construction supervisory body in
case you need prior approval for installation of this
product.
• Mandatory is the installation of smoke detectors in
the room where the burner is installed.
• Pellet burner is NOT designed for installation in
motorhomes, caravans etc.

1.2.2. Instructions to installation user

CAUTION! Danger of injury / damage of
system due to incompetent operation.
- The pellet burner must be serviced only
by persons familiar with the operation
manual.

- As a user, you are only allowed to start the
pellet burner up, adjust the temperature
of the burner, shut the burner down and
clean it.
- Unattended children must not be allowed
access to premises with running pellet
burner inside.
It is mandatory to assure a backup

power generator of corresponding
rated power! (see 11.3)
4