Kenwood KDC-BT740DAB Bedienungsanleitung Seite 42

Installation/Connection
Connect external components
No Part
1
Microphone input jack (Page 17)
2 Output terminals
FRONT: Front output (2-way crossover) / Mid Range output (3-way crossover)
REAR/SW: Rear/subwoofer output (2-way crossover) / Woofer output (3-way crossover)
• When connecting an external amplifier to the output terminals of this unit, securely
connect the amplifier ground wire to the car chassis to prevent damage to the unit.
3 DAB antenna jack (Page 7, 37)
34
ENGLISH
Installing the DAB antenna
Connect the supplied DAB antenna to the DAB antenna jack. (See the left
column.)
CAUTION
• The film antenna (F) is exclusively for use inside the vehicle.
• Do not install at the following locations:
– where it may block the driver's view.
– where it may obstruct the operation of safety devices such as air bags.
– on movable glass surfaces such as the rear hatch.
– at side of vehicle (e.g. door, front quarter window).
– on rear window.
• Signal strength will weaken when installed at the following locations:
– on IR reflecting glass or locations covered with mirror type glass film.
– where it overlaps with genuine radio antenna (pattern).
– where it overlaps with window heating wires.
– on glass that blocks radio signals (e.g. IR reflecting glass, thermal
insulation glass).
• Poor reception may occur:
– due to noise when windscreen wiper, air conditioner, or motor is turned
on.
– depending on the direction of the broadcast station with respect to the
vehicle (antenna).
• Thoroughly wipe oil and dirt from the pasting surface with the supplied
cleaner (I).
• Do not bend or damage the film antenna (F).
• It may not be possible to install on certain vehicles.
• Check the cable routing of the film antenna (F) and amplifier unit (G)
before pasting.
• Do not apply any glass cleaner after pasting the film antenna (F).