FLAEM Wi.Neb Bedienungsanleitung Seite 17

CLEANING SANITISATION DISINFECTION
Switch off the device before any cleaning procedure and unplug the power cable from the socket.
DEVICE AND TUBING EXTERIOR
Use only a damp cloth with antibacterial soap (non-abrasive and with no solvents of any sort).
method C: Sanitise accessories F-G.1-G.2-G.3-G.4-H-I-L-M by immersing them in a solution of 50% water and 50%
white vinegar, then rinse thoroughly under potable hot water (approximately 40 °C).
If you want to also perform the cleaning for DISINFECTION, jump to the DISINFECTION paragraph.
DISINFECTION
After sanitising the nebuliser cup and the accessories, disinfect them choosing one of the methods described below.
method A: Accessories G.1-G.2-G.3-G.4-H-I-L-M can be disinfected.
The disinfectant must be an electrolytic chloroxidizer (active principle: sodium hypochlorite) specific for disinfecting,
which is available in any pharmacy.
Implementation:
- Fill a container big enough to hold all of the parts to disinfect with a solution of potable water and disinfectant, accord-
ing to the proportions indicated on the packaging of the disinfectant.
- Completely immerse each part in the solution, taking care to avoid the formation of air bubbles on the parts. Leave the
parts immersed for the amount of time indicated on the packaging of the disinfectant associated with the concentra-
tion chosen for the solution.
- Remove the disinfected parts and rinse abundantly with warm potable water.
- Dispose of the solution following the instructions provided by the disinfectant manufacturer.
method B: Sanitise the accessories G.1-G.2-G.3-G.4-H-I-L-M by boiling them in water for 10 minutes; use
demineralised or distilled water to prevent calcium deposits.
method C: Sanitise the accessories G.1-G.2-G.3-G.4-H-I-L-M with a hot steam steriliser for baby-bottle (not the
microwave type). Perform the process faithfully following the instructions of the steriliser. To ensure that the disinfection
is effective, choose a steriliser with an operating cycle of at least 6 minutes.
At the end of each use store the device complete with accessories in a dry place away from dust.
ACCESSORIES
Open the nebuliser by turning the upper part (G1) anticlockwise,
remove the nozzle (G2) from the upper part (G1) by pressing as
shown by the 2 arrows in the "Connection diagram" in point G.
Then proceed according to the following instructions.
SANITISATION
Before and after each use, sanitise the nebuliser cup and the
accessories, choosing one of the methods described below.
method A: Sanitise accessories F-G.1-G.2-G.3-G.4-H-
I-L-M under potable hot water (approximately 40°C) with a
gentle, non abrasive dish detergent.
method B: Sanitise accessoriesF-G.1-G.2-G.3-G.4-H-I-
L-M in the dishwasher with a hot cycle.
ENGLISH
- 15