Inhaltsverzeichnis
Werbung
MT-4315 / MT-4316
Set the target value by turning the knob
. Pitch – 1 minute. Press
again; the hours indicator will begin to flash. Set the target value by turning the knob
.
Pitch – 1 hour. Then press
and set the target value of the cooking temperature by turning the knob
. Pitch - 1°C. Press the button
to confirm the
settings of the first phase in the SMART program. Set the cooking time/temperature settings of as many phases as you need in the same manner as described above for up
to nine phases. Press and hold the button
for 2 seconds to start the SMART program. It will execute as many phases as programmed. Phases which have a zero
value of cooking time will not start. All customized settings will be stored in the memory for future use. The user may also adjust cooking settings of any phase during runtime
of the SMART but those changes will not be saved in the memory.
ATTENTION! Check how many phases have been programmed earlier! If, for example, three phases were used last time but only two are needed now,
please do not forget to set the value at zero cooking time for the third phase. This can be done by entering into edit mode of the third phase and resetting the
cooking time to 00:00 in the manner described above.
«MULTICOOKER»
Choose Multicooker by turning the knob
. The Multicooker icon
will light up and the display will show the program‟s default settings: (10 minutes / 30°C).
Press
; the minute indicator will begin flashing on the display. Set the target value by turning the knob
. Pitch – 1 min. Press
again; the hour indicator will
begin flashing. Set the target value by turning the knob
. Pitch – 1 hour. Press
to edit the cooking temperature. Set the target value by turning the
knob
. Pitch – 1°C. Press and hold the button
for 2 seconds to start the Multicooker program with your customized settings. The user can change the
cooking settings during runtime.
38
Werbung
Inhaltsverzeichnis
