Manual Tuning - Peaq PMS300 Bedienungsanleitung

47
Tuner playback
Amplifier unit must be in DAB or FM mode to
run tuner operation. Use buttons on remote
control or use respective operating elements
on the front panel of the appliance.
DAB / FM
Press DAB/FM to switch from DAB to FM
radio.
INFORMATION
In DAB or FM mode press INFO/RAN to ac-
tivate DAB information or RDS (Radio Data
System) on FM stations.
NOTE: In DAB mode the signal strength is
also displayed if the station is stored.
AUTO TUNING
Press AUTO TUNE to auto scan and auto
stop when a new station is found. During
search Q SCAN is displayed.
Press AUTO TUNE for 2-3 seconds for a full
scan. During search F SCAN is displayed.
NOTE: The L band can only be tuned manu-
ally.

MANUAL TUNING

Press UP or DOWN to search for stations
manually or use the TUNING +/- conrol on
the front panel.
NOTE: In DAB mode press ENTER to select
the current station or set the AUTO ENTER
function to ON.
Press ENTER on the remote control for 2-3
seconds, to set AUTO ENTER function ON
or OFF.
ANTENNA
In DAB mode, press INFO to display the
signal quality. Try different antenna routings
for best signal reception.
SAVING STATIONS
Once a station is found, press the respec-
tive number button 0-9 / +10 on the remote
control for 3 seconds to store the channel.
Alternatively press SAVE together with
BROWSE on the front panel.
CYCLE STORED STATIONS
Press PRE +/- to cycle through the stored
stations or press the recpective number but-
ton 0-9 / +10 on the remote control.
Alternatively press BROWSE on the front
panel.
RESET STATIONS
To delete all stored stations, press and hold
INFO until RESET is displayed. Then press
ENTER to confirm.
STEREO / MONO
Press ENTER on the front panel to set
STEREO or MONO mode.
ENGLISH