Aux Operation; Setting The Alarm - oneConcept 10006663 Bedienungsanleitung

BT Operation
1.Turn on the Music System by pressing the STAND-BY BUTTON. The LCD DISPLAY lights on.
2. Press MODE button to choose the BT mode. The BT light will flash.
3.Open the BT device and search other BT devices. Choose V329 and connect.
4. Play the music: The BT will remember the last connection and will connect it automati-
cally. It may cause that the music system can not connect to others if it connects too
many devices. Please hold PLAY/PAUSE Button two seconds to clean the memory.
You can play other music sources (iPod, MP3 player or other digital audio player) through
the speakers of this System by connecting the AUX IN Jack to your external player's LINE
OUT jack or headphone jack.
1. The AUX IN and PHONES JACKS are covered by the DOOR (#16). Slide the DOOR downwards
2. Plug one end of an audio cable (Not included) into the AUX IN Jack and the other end of
the cable to the line out or headphone jack of your digital audio player.
3. Press the STAND-BY BUTTON to turn on the System. The LCD DISPLAY goes "On".
4. Play your digital audio player.
5. Adjust the VOLUME on the external audio player and the System until you reach a com-
fortable listening level.
6. Turn the System and your audio player off when you have finished listening and unplug
the audio cable.
SETTING THE WAKE UP TIME and Alarm to FM/CD/USB/CARD/Buzzer
1. Under stand-by status, press ALARM SET button more than 2 seconds, the alarm time
on display will flsh for 6 seconds.
2. Within 10 seconds Press HOUR button and MINUTE to adjust the time and press Alarm
Set button again to member the setting.
3. Within 10 seconds ,press ALARM SET button to select the timer playback
(FM,CD.USB.CARD, Buzzer)
4. Hold down ALARM SET button for 2 seconds,the display will show the "MEMERY".
5. When the timer end time is reached, the system will enter the power stand-by mode
automatically.
Notes: When performing timer playback using another unit connected to the USB terminal
or SD , select "USB" or "SD" in step 3. This unit will turn on or enter the power stand-by
mode automatically.
(10009513, 10009514)

AUX Operation

Setting the Alarm

source
17