Using The Heater; After-Sales Service - EWT CLIMA 903TLS Bedienungsanleitung

Using the Heater

Heat Control - see Fig. 2
-
Off
-
Cool Blow*
-
Half Heat
-
Full Heat
Thermostat Control - see Fig. 3
The heat output is controlled by the thermostat,
according to the room temperature.
Turn the thermostat knob fully clockwise to
maximum setting initially. When the room is warm
enough, reduce the setting slowly until the heater
just clicks off.
The heater will now cycle on and off to maintain
your selected room temperature. An audible click
may be heard when the thermostat operates - this
is normal.
Note : If the heater does not come on when the
thermostat is at a low setting, this is normally
because the room is warmer than the thermostat
setting and is not a fault.
* When the heat control is set to ' ' or cool blow,
set the thermostat control to maximum.
Position ' ' will turn the heater on and off to
maintain a temperature of approximately 5°C.
Safety
Overheat Protection
For your safety, this appliance is fitted with a
thermal cut-out. In the event that the product
overheats, the cut-out switches the heater off
automatically. To bring the heater back into
operation, remove the cause of overheating, then
turn off the electrical supply to the heater for a
few minutes.
When the heater has cooled sufficiently reconnect
and switch on the heater. If the cut-out operates
repeatedly, contact your supplier.
Fuselink
A thermal fuse link is provided as an added safety
feature. If the fuse link operates and opens circuit
it is the result of abnormal overheating within the
appliance and servicing of the appliance by a
competent service engineer will be required in
order to ensure the future safe operation of the
heater.
Cleaning
WARNING: Always disconnect from power supply
before cleaning heater.
Do not use detergents, abrasive cleaning powders
or polish of any kind on the heater.
Wipe with a dry cloth to remove dust and a damp
cloth (not wet) to clean off stains. Be careful not
to allow moisture into the heater.
Ensure that dust or fluff does not accumulate
inside the heater as this could lead to overheating
of the element. Use a vacuum cleaner to remove
any fluff which does accumulate.
Recycling
For electrical products sold within
the European Community.
At the end of the electrical products
useful life it should not be disposed
of with household waste. Please
recycle where facilities exist. Check
with your Local Authority or retailer
for recycling advice in your country.
After Sales Service
Should you require after sales service, please
contact the retailer from whom the appliance was
purchased or contact the service number relevant
to your country on the warranty card.
Please do not return a faulty product to us in the
first instance as this may result in loss or damage
and delay in providing you with a satisfactory
service.
Please retain your receipt as proof of purchase.
Model Identifier(s):
Heat output
Nominal heat output
Minimum heat output (indicative)
Maximum continuous heat output
Auxiliary electricity Consumption
At nominal heat output
At minimum heat output
In standby mode
Type of heat output/ room temperature control
Mechanical thermostat room temperature control
Contact details
CLIMA 903TLS
Pnom 3.0
Pmin 1.5
Pmax,c 3.0
elmax 0.0
elmin 0.0
elSB 0.0
GDHVI
Barn Road, Dunleer, Co. Louth,
Ireland
kW
kW
kW
kW
kW
kW
Yes