Technical Data; Intended Use; Safety Information - Livarno Living IAN 317530 Aufbauanleitung

Congratulations!
You have chosen to purchase a high-quality item.
Familiarise yourself with the item before using it
for the first time.
Read the following assembly
instructions and the safety informa-
tion carefully.
Only use this item in the manner described and
for the purpose for which it is intended. Store
these assembly instructions carefully. When
passing the item on to third parties, please also
hand over all accompanying documents.
Package contents (Fig. A)
1 x backrest (1)
1 x seat (2)
1 x 5-star base (3)
1 x armrest, right (4)
1 x armrest, left (5)
1 x plate (6)
5 x castor (7)
1 x gas spring (8)
1 x gas spring cover, 3-part (9)
6 x screw, short (10)
8 x screw, long (11)
1 x Allen key (12)
1 x assembly instructions

Technical data

Not suitable for carpeted floors
Maximum load: 110kg
110
Date of manufacture (month/year):
06/2019

Intended use

The item is not intended for commercial used.
This item has been developed for private indoor
use.

Safety information

Life-threatening hazard!
• Never leave children unsupervised with the
packaging materials. There is a risk of suffoca-
tion.
8 GB/CY
Risk of injury!
• Make sure the item is stabilised before use.
• Place the item on a level surface.
• The item may only be used under adult super-
vision, and should not be used as a toy.
• The item is not a toy or a climbing apparatus!
Ensure that persons, especially children, do
not pull themselves up on the item or lean
against it. The item can tip over.
• Check the item for damage or wear before
each use. Use the item only if it is in perfect
condition!
• Ensure that the item has been assembled
properly and in accordance with these instruc-
tions for use. Improper assembly can lead
to injuries and impair the item's safety and
functionality.
• The gas spring may only be replaced or
repaired by a trained professional.
• Never stand on the item.
Assembly
1. Insert the castors (7) into each castor guide
(3a) in the 5-star base (3) (Fig. B).
2. Next insert the gas spring (8) into the base (3)
and then place the gas spring cover (9) over
the gas spring (8) (Fig. C).
3. Screw the plate (6) onto the underside of the
seat (2) with the short screws (10) (Fig. D).
Note: pay attention to the correct alignment of
the plate.
4. Screw the right armrest (4) and the left armrest
(5) onto the seat (2) with the long screws (11)
(Fig. E).
5. Screw the backrest (1) onto the seat (2) with
the screws (10) and (11) (Fig. F).
Note: screw the screws in loosely at first, and
tighten them completely once the item is com-
pletely assembled.
6. Insert the gas spring (8) into the plate (6)
(Fig. G). Put the assembled item under strain
to tightly connect the parts together.