Endress+Hauser RIA 550 Betriebsanleitung Seite 34

Process display
CAL Calibrate single set points
DADJ Calibrate dot matrix display
(only 2 channel) brightness
RTMP Display internal compensation
temperature (only on universal
input option)
Option universal input:
Bipolar voltage input:
+/-20 mV, +/-50 mV, +/-100 mV, +/-200 mV, +/-1 V, +/-2 V, +/-5 V, +/-10 V; Ri = 1MΩ
Current input:
0/4..20 mA; Ri = 50Ω
Thermocouple:
Typ L -200..+900°C; Typ U -200..+600°C; Typ B 200..+1820°C; Typ S 0..+1800°C; Typ R -50..+1800°C;
Typ K -200..+1372°C; Typ J -210..+1200°C; Typ T -270.. +400°C; Typ N -270..+1300°C ;
With cable open cicuit monitor.
RTD input:
Ni100 -60..+180°C; Pt1000 -100..+600°C; Pt500 -100..+600°C; Pt1000 -100..+600°C;
Presettable engineering units:
"OFF", "bar", "C/kg", "cal", "cd", "cm", "cm2", "cm3", "dB", "G", "g/h", "g/l", "g/m3", "g/ml", "g/s", "gal" , "HZ",
"kg/s", "km/h", "kPa", "kV", "kVar", "kW", "kWh", "kΩ", "l", "l/h", "l/s", "lb/h", "lm", "m", "m/h", "m/s", "m/s2",
"m3/d", "m3/h", "m3/s", "mbar", "mg/l", "mm", "mm2", "mm3", "MPa", "mPa", "mR/h", "ms", "mΩ", "MΩ", "mV",
"Mvar", " MW", "MWh", "N", "N/m2", "Nm", "oz", "pH", "ppb", "ppm", "rem", "s", "t", "t/s", "V", "VA","Var",
"Vol%", "Wh", "Ω", "µA", "µF", "µm", "µs", "µS", "µΩ", "µV", "% ", "°C"
32
Operation matrix
0 % 0 % set point
20 % 20 % set point
50 % 50 % set point
80 % 80 set point
100 % 100 % set point
SAVE Accept and store calibrated values.
-4 = Upper display darker
Lower display brighter
+4= Upper display brighter
Lower display darker
xx °C