INTERTECHNO ITKL-30 Bedienungsanleitung Seite 29

GB
Operating instructions
ITKL-30
How to erase codes
To erase the encoding, proceed as described above in 3.) to 5.), but now
the off signal is transmitted by pressing twice.
The LED will light up red 2x.
How to save scene switching
Only for wireless receivers which are suitable for scene switching
3
(SYMBOL)!!
3 different scenes can be saved. (Fig. 1)
Scene settings are automatically adopted if two or more scene
switching-compatible transmitters are used and encoded with the same
wireless receivers.
To set a scene with several wireless receivers, it is recommended you use
a handheld transmitter such as the ITLS-16, ITT-1500, etc.
Use it to set your wireless receivers to the desired state, e.g. dimmer
setting (setting the desired brightness) or switching them on or off.
If no other handheld transmitter is available, the wireless pocket scene
transmitter in slider position 1 can be used to program the settings of
one wireless receiver after another, the last selected brightness setting
remains the same for dimmers when they are switched off.
Scene 1: Move the slider to position 3 (Fig. 3) and press once for scene 1.
The LED will light up green 3x as confirmation and orange 1x for scene 1.
Scene 1 is saved!
Scene 2: Again select the settings and move the slider to position 3 and
finally press 2x. The LED will light up orange 2x.
Scene 3 is taught in by pressing 3x, the LED will light up green 3x and
orange 3x.
If all 3 scenes have been saved, move the slider to position 2.
Press accordingly to activate each scene.
1x for scene 1 the LED will light up orange 1x as confirmation
2x for scene 2 the LED will light up orange 2x as confirmation
3x for scene 3 the LED will light up orange 3x as confirmation
›