Installation - Cellular Line INTERPHONE Bedienungsanleitungen

Installation

IMPORTANT: The kit supplied contains two types of sliding supports to
mount onto the helmet, one adhesive (D) (fixed) and the other with a
removable clip (C) using two screws.
Use the one most suitable for the type of helmet you own.
USING THE SLIDING SUPPORT WITH REMOVABLE CLIP (C)
Take the support and look for the most appropriate place for fixing on
the side of the helmet (on the right or left, as you prefer), insert the back
part of the clip inside the helmet and pair the other part on the outside
(photo I), insert the screws and tighten them (photo L), check the posi-
tion and, if necessary, slide the support to move it and tighten the
screws with the small screwdriver supplied (H) with the kit.
N.B.: the support also has an integrated adaptor (E) to compensate
possible differences in thickness that can occur between helmets. The
adaptor is mounted between the two parts that make up the sliding
support (photo Z) using the two longer screws supplied with the kit.
MOUNTING THE SLIDING SUPPORT WITH ADHESIVE
1. Take the adhesive support (D) and find the best side and place to
position it. Clean the part of the helmet to which the support will be
attached and remove any grease (do not use cleaners that may
damage the helmet). Remove the protective strip from the double-
sided tape and apply the support to the helmet (photo P). Once the
support has been attached to the helmet it will not be possible to
move it, so please take care when choosing its position.
2. Once the helmet support has been mounted, take the Bluetooth
module and insert it from above into the guide (photo M). Check that
the Bluetooth module is correctly blocked in position, by trying to
extract it, pulling upwards (photo N).
N.B.: the module must always been inserted from above. Whether
the kit is positioned on the right or the left of the helmet, the con-
nector for the headset and microphone must always be below the
Bluetooth module.
3. Now take the Velcro strip (G) and apply it to the inside of the helmet
using the double-sided tape adhesive (photo Q). Position it at the
height of your ear when wearing the helmet.
N.B.: before positioning the Velcro it is advisable to carry out a pre-
liminary test by wearing the helmet to check the most suitable
position in which to place it.
Once this is done, apply the headset with microphone (B) to the
Velcro you have just placed on the helmet (photo R).
INTERPHONE
GB
21