Installing Your Wine Cellar; Unpacking Your Wine Cellar; Leveling Your Wine Cellar; Proper Air Circulation - Haier WS50GA Bedienungsanleitung

English
11.
If the light is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
This appliance is intended to be used exclusively for the
12.
storage of wine.
13. Risk of child entrapment. Before you throw away your old
wine cellar, take off the doors. Leave the shelves in place
so that children may not easily climb inside.

Installing Your Wine Cellar

Unpacking Your Wine Cellar

1. Remove all packaging material. This includes the foam base and
all adhesive tape holding the wine cellar accessories inside and
outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the wine cellar.

Leveling Your Wine Cellar

• Your wine cellar has leveling legs which are located in the front
and rear corners of your wine cellar. After properly placing your
wine cellar in its final position, you can level your wine cellar.
• Leveling legs can be adjusted by turning them clockwise to raise
your wine cellar or by turning them counterclockwise to lower your
wine cellar. The wine cellar door will close easier when the leveling
legs are extended.

Proper Air Circulation

• To assure your wine cellar works at the maximum efficiency it
was designed for, you should install it in a location where there is
proper air circulation, plumbing and electrical connections.
• The following are recommended clearances around the wine
cellar:
Sides.......................... 2" (50mm)
Top............................. 2" (50mm)
Back........................... 2" (50mm)
• Do not over fill your wine cellar for proper wine cooling.
Note: If your wine cellar has been tilted for any reason, wait 24 hours
before plugging it in.
2