Spare Parts; Special Accessories - Hansgrohe Axor Allegroh 36004000 Montageanleitung

Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the slide washer, washer and collar nut over
the threaded base and tighten the collar nut by
hand.
4. Tighten screws.
5. Connect the supply pipes to the angle valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
Large differences in pressure between the hot and cold
water supply should be balanced.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water, swivel to the right = cold
water.
Technical Data
This mixer series-produced with
waterdimmer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer
(flow limiter 8a) located behind the mousseur must
be removed.
To adjust the hot water limiter on single lever mixers,
please see page 13.
No adjustment is necessary when using a
continuous flow water heater.
6
English

Spare parts

1
1.1 screw cover
2
3
4
5
6
7
8
9
9.1 pull knob
10

Special accessories

X
7 l/min 3 bars
14 l/min 3 bars
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
lever head without mouthspray
connection
flange
cartridge without mouthspray
connection
service set
nut
seals (5)
mixer ball without mouthspray
connection
mousseur cpl. (10)
mousseur gold plated
pull rod cpl.
fixation cpl.
special tool set
(not part of delivery)
36092
94063
94130
14095000
13952000
13918000
13962000
13964000
13085000
94980990
92620
94066
13961000
58085000