Cleaning The Tank - Bauhaus DIESELHEIZER 10 Technische Daten

6. FUNCTIONING
en
WARNING: Thoroughly
it
"INFORMATION REGADRING SAFETY",
before switching the generator on.
de
es 6.1 SWITCHING THE GENERATOR
ON:
fr
►I°. Follow all instructions relative to safety.
►II°. Check the presence of fuel in the tank.
nl
►III°. Close the tank cap.
pt
►IV°. Connect the power supply plug to
the mains electricity (SEE VOLTAGE IN
da
"TECHNICAL DATA TABLE").
►V°. Take the "ON/OFF" switch to the "ON"
fi
(|) position (SEE FIG. 3-4). The generator
no
should switch-on within a few seconds. If
the generator does not start, consult the
sv
"11. TROUBLESHOOTING" paragraph.
pl ►VI°. For the models with room thermostat,
check the position of the knob (SEE FIG. 5).
ru
N.B.: IF THE
SWITCH-OFF DUE TO THE LACK OF
cs
FUEL, TOP-UP THE TANK AND RESET
hu
THE GENERATOR (SEE PAR. 6.2).
6.2 RESETTING THE GENERATOR:
sl
In the models with automatic "RESET", switch
tr
the generator off and back on again (SEE
FIG. 3-4).
hr
6.3 SWITCHING THE GENERATOR
lt
OFF:
►I°. Take the "ON/OFF" switch to the "OFF"
lv
(O) position (SEE FIG. 3-4).
et
7. REGULATING THE
ro
PRESSURE OF THE
sk
COMPRESSOR
THE COMPRESSOR
bg
HAVE TO BE RESTORED WITH WEAR OF
uk
THE GENERATOR.
►I°. Use the "TECHNICAL DATA TABLE"
bs
to identify the correct pressure (Bar - PSI -
kPa) of your generator.
el
►II°. Remove the screw/cap of the manometer
zh
connection (A).
►III°. Assemble the manometer (not supplied,
see "ACCESSORIES").
►IV°. Switch the generator on.
►V°. Act on the regulation screw by turning
it clockwise to increase the pressure and
anti-clockwise to decrease it (B).
►VI°. Remove the manometer and restore
the screw/cap (A).
read
GENERATOR SHOULD
(SEE FIG. 6)
PRESSURE

8. CLEANING THE TANK

FILTER
the
DEPENDING ON THE QUALITY OF THE
FUEL THAT IS USED, THE TANK FILTER
MAY HAVE TO BE CLEANED.
►I°. Remove the cap (A) from the tank.
►II°. Extract the filter (B) from the tank.
►III°. Clean the filter (B) with clean fuel,
paying attention not to damage it.
►IV°. Re-mount the filter (B) in the tank.
►V°. Close the cap (A).
9. PRESERVATION AND
TRANSPORT
I ORDER TO KEEP AND/OR TRANSPORTAR
THE GENERATOR IN THE BEST WAY,
STHE FOLLOWING PROCEDURE MUST
BE FOLLOWED:
►I°. Empty the fuel tank (some models have
a draining cap on the bottom of the tank. In
this case, remove the drain cap and empty
the fuel).
►II°. If the presence of residues is noted, pour
clean fuel into the tank and drain off again.
►III°. Close the tank cap and/or the draining
cap and dispose of the fuel appropriately
according to the Standards in force.
►IV°. In order to keep the generator in the
best way possible, it must be kept on a level
surface to prevent the escape of fuel and in
a dry place away from any possible external
threats.
MAY
(SEE FIG. 7)