Intended Use; Control Keys - Bosch 1 687 246 029 Originalbetriebsanleitung

en

6 | 1 687 246 029 | Intended use

1. Intended use
The 1 687 246 029 infrared remote control ("remote
control" in the following) can be used to operate up to
four BEA 750 units. There are four channels for control
and operation that can be set by the remote control.
2.

Control keys

2 3 4
G1 G2 CT
1
F1 F2 F3
F5 F6 F7
G1 G2 CT
F1 F2 F3
F5 F6 F7
1
13
Fig. 1: Remote control – basic key functions
1 <F1> to <F12> function keys (BEA
2 <G1> range for setting channels
3 <G2> range for setting channels
4 <CT> range (no function)
5 <F4> function key for changing channels
6 Cursor keys
7 <OK> key (enter)
8 <ESC> key
9 <TAB> key
10 <M> key (no function)
11 <K/R> key (no function)
12 <CH> key for setting channels
13 <F1> to <F12> function keys (no function)
Channel-key assignment
The 4 available channels are assigned to the function
keys in the <G1> and <G2> ranges: <F1> = channel 1,
<F2> = channel 2, <F5> = channel 5, <F6> = channel 6.
|
1 689 989 338 2017-05-10
5
6
1
7
8
9
10
11
12
750 hard and soft keys)
3. Initial commissioning
i
During initial commissioning, set the channel of the
remote control to the channel of the receiver of the
BEA 750. The BEA 750 receiver is set to channel 1 by
the factory.
¶
Press and hold <CH> (fig. 1, item 12) and the <F1>
function key of the <G1> range (fig. 1, item 2) simul-
taneously for 4 seconds.
? The remote control is set to channel 1.
? The remote control is now assigned to BEA 750
on channel 1.
Automotive Service Solutions