Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Checking the radio link (control panel in test mode)
I
Œ
Briefly press the detector test button to change it to test mode. The red test indica-
tor light will come on while the button is pressed. fter pressing the test button,
you can test movement detection for 90 seconds.
Check the control panel reacts.
Ž
Move in front of the detector once or several times. When you are detected, the
indicator light will come on. If necessary, modify the direction of the detector.
Let the pet circulate freely in the room in order to verify there is no detection.
!
When the direction is correct, open the detector case and lock the adjustment axis
in position without over tightening.
fter the test period, the detector goes into normal operation and the
indicator lamp no longer comes on each time someone is detected.
Perform a real system test.
CH NGING THE B TTERIES
The control panel indicates a motion detector battery fault when it is put into opera-
tion. To identify the faulty detector, press each test button; if the indicator lamp does
not light up, the battery must be changed. To change the battery:
Œ
take a remote control,
open the detector case whilst pressing the Stop button on the remote control (§
Opening),
Ž
remove the 2 used batteries and wait 2 minutes before connecting the
new batteries (all previous programming remains in the memory),
fit the 2 new alkaline LR03 – 1.5 V batteries taking care to ensure correct polarity
(refer to the indications in the battery housing),
reclose the detector,
‘
wait 90 s (for the detection lens to stabilize),
’
press the test button and check the coverage zone; the red indicator lamp lights
up each time it detects you.
The batteries must be replaced with alkaline batteries of the same type.
!
Please dispose of the old batteries in a container for this purpose.
47
GB
GB
Pile
Werbung
Inhaltsverzeichnis
