diagral DM260W Bedienungsanleitung Seite 45


Testing the chosen group (control panel in test mode)
Press the motion detector test key briefly and verify the correct
indicator light and the panel unit.
Long
screw
Back plate
For reasons of security and long life of the detector battery, the installation of the
!
anti-tamper pin is obligatory. If the pin is forgotten or installed incorrectly , the
red indicator light will blink permanently when the detector is fitted to its
bracket.
To fix on an adjustment axis
I
If you choose bracket mounting, the n° 0 tam-
per pin is already fitted in the detector at the
factory.
Œ
Hold the back plate on the wall in the desired posi-
tion to mark where to drill the holes.

Drill the wall
Ž
Insert the long screw into the back plate and fasten
the back plate to the wall.

Put the back plate cover in place

ssemble the two parts of the adjustment axis.
‘
Insert the adjustment axis into the long screw
’
Position the base of the motion detector (a figure
shows the top of the base)
“
Tighten the securing screw, but not too much, so that
the direction of the motion detector can be adjusted.
”
Place the motion detector on the base and turn it to
approximately the right angle.
FIXING
Order in which to assemble the parts
djustment
axis
Back plate cover
ND TESTING
Screw +
tightening
washer
45
Pin n° 1
Pin n° 2
Selection
of anti tamper pins
Figure
Pin n° 0
use when fixing
with an adjustment
axis (already fitted
in the factory)
GB GB