Front View; Power Supply - diagral DM260W Bedienungsanleitung

INST LLING
FIG.

Front view

Locking screw.
Œ
Light indicator (under the detection lens).

FIG. B
Opening (control panel in test mode)
Open the case by unscrewing the locking screw.
FIG. C
Guarantee sticker
Remove the pre-cut section of the guarantee sticker located
G
under the battery housing (rear cover open) and stick it on to
the guarantee extension request supplied.
When the system installation is finished, please complete and return the garantee
G
extension request form, supplied with these Installation Instructions.
FIG. D

Power supply

Fit the 2 batteries taking care to ensure cor-
rect polarity.
Repeated flashing of the red indicator
!
lamps is normal when the detector is not
clipped onto its base.
FIG. E
Code your detector
Programming the personalised radio code
I
Œ
Use the personalised radio code selected in § "Selecting a personalised radio
code" in the guide to the system.
Personalised radio code
Motion detector code

On the 2nd line of the table, fill in a "0" (zero) below each cross.
Ž
Fill in the empty boxes of the second line with a "1" (one).

Program the radio code on the detector as indicated below:
1
0
Start programming
by pressing
both keys
simultaneously
until the indicator
light goes out.
If you make a mistake, the red indicator light will flash quickly. Repeat the pro-
!
cedure from the beginning. t the end of programming the LED indicator lamps
flash normally and will stop as soon as the device has been firmly fixed on to its base.
Detection lens.

Enter the sequence
of 10 short key presses
corresponding to the
personalised radio code.
Test button.
Ž
D
101744541000
101744541000
1 2 3 4
Confirm the programming by
pressing both keys simultaneously
until the indicator light goes out. The
on for 5 seconds to indicate the pro-
gramming has been successful.
43
B
Ž


Œ
C
E
Programming
indicator light
0
Guarantee
sticker
5 6 7 8
1
0
indicator light will come
GB GB
123456789012
1
101744541000
101744541000
9 10