diagral DM260W Bedienungsanleitung Seite 46

GB GB
When fixing the movement detector
!
at an angle or flat against the wall,
fix the label (provided in the sachet
of accessories) on the reverse side
of the product in order to cover the
opening to avoid insects getting through.
To fix flat
I
Œ
Select the pre-drilled holes in the base of the motion
detector for fixing flat.

Hold the back plate on the wall in the desired posi-
tion to mark where to drill the holes (a figure indi-
cates the top of the base).
Ž
Drill the wall and fix the base

Remove the factory fitted anti-tamper pin no. 0.

Detach pin n° 1 from the selection
supplied
‘
Put the tamper protection pin in
place.
’
Position the motion detector on the
base.
To fix in a corner
I
Œ
Select the pre-drilled holes in the base of the motion
detector for corner fixing.

Hold the back plate on the wall in the desired posi-
tion to mark where to drill the holes (a figure indi-
cates the top of the base).
Ž
Drill the wall and fix the base.

Remove the factory fitted anti-tamper pin no. 0.

Detach pin n° 2 from the selection supplied
‘
Place the anti tamper pin in position.
’
Place the motion detector on the
base.
Si fixation en angle ou à plat contre un mur
For a fixing in a corner or flat against the wall
Si fixation en angle ou à plat contre un mur
For a fixing in a corner or flat against the wall
Figure
Figure
46
2
1
653563_A
Pre-drilled holes
2 fixing
screws
Pin n° 1
Use when
fixing flat
Pre-drilled holes
2 fixing screws
90°
Pin n° 2
Use when fixing
in a corner