Terms And Conditions Of Warranty - KAWMET w1 co Bedienungsanleitung Und Garantiekarte

Flames are too Too much combustion air
high – they fill
entire hearth
Too intensive chimney draft
Poor quality wood
When setting the Cold flue chimney
fire, smoke gets
into the room
When loading Insufficient chimney draft
next charge of
wood to the fire-
place, smoke gets
into the room
The wind gets into the
chimney
Heat output is Poor quality wood
too small
Insufficient heat transfer
Glass gets dirty Insufficient chimney draft
very quickly
Insufficient air supply
Poor quality wood
Intensive Too much moisture in wood
condensation of
water inside the
fireplace
The rain gets into the
chimney

13. terms and conditions of warranty

1. Guarantee the smooth operation of the fireplace confirmed a stamp of producer, or a retailer and signed by the seller
shall be granted for a period of 24 months from the date of purchase.
2. In case of damage during the warranty period of defects in material or manufacturer provides free repair.
3. Any damage caused by improper storage, improper operation and maintenance of poor, inconsistent with the
conditions specified in the instruction manual and use, and as a result of other causes not the fault of the manufacturer
will void the warranty.
4. Warranty does not include the glass, seals and parts where damage is caused by careless and improper conduct user
instructions, in particular:
◊ using of fuels other than wood,
◊ loading of fuel to the maximum,
◊ a very intense firing up, when the furnace is not hot,
www.kawmet.pl
Decrease air supply by closing the air intake diaphragm.
Order the installation of automatic regulator of chimney draft.
Use hard wood from deciduous trees like oak, hornbeam, beech, ash . Do
not use conifer wood.
Heat up the flue chimney – to set a fire use for example paper or very
small pieces of wood.
Check if the flue gas damper is not closed (open in case it is closed).
Arrange an inspection of chimney flue to check if there is no leakage or if
the flue is not clogged (clean if needed).
Install the cowl on the chimney outlet – it will not allow wind to go into the
chimney.
Use hard wood from deciduous trees like oak, hornbeam, beech, ash . Do
not use conifer wood.
Check if the inlet and outlet grilles are the appropriate size, recommended
by the manufacturer. Check if the grilles are not clogged. Ensure that
there is sufficient air circulation between rooms.
Check if the flue gas damper is not closed (open in case it is closed or
adjust to eliminate the effect) .
Increase air supply by opening the air intake diaphragm and secondary
air intake diaphragm (if equipped). Check if the ash pan chamber and
ash pan itself are not full of ash – if yes, empty the ash pan and clean the
chamber.
Use hard wood from deciduous trees like oak, hornbeam, beech, ash,
that moisture content not exceeds 20% (seasoned wood for 2 years in a
covered and well-ventilated place).
Use wood that moisture content not exceeds 20% (seasoned wood for 2
years in a covered and well-ventilated place).
Install the cowl on the chimney outlet – it will not allow water to get into
the chimney.
47