Chimney Fire - KAWMET w1 co Bedienungsanleitung Und Garantiekarte

• With the unit at the time of firing, there may be smoke if you installed a ventilation system creates a vacuum in the room
where the appliance is located, this applies to most rooms equipped with a mechanical extraction system VMC (such as the
kitchen, etc.)
• Ensure that the air required for burning can be taken in sufficient quantities from the room where the stove is installed. If
the structure of the building is such that the amount of air is too small to provide oxidation and ventilation should be provided
for the installation of additional air supply.
7. Maintenance policies
ash removing
The ash must be removed when it is necessary. Excess ash obstructs air flow, which is needed for combustion, and can cause
hearth overheating and even damage.. Ashes should be place into a metal container equipped with a tight lid. The container should
be placed on non-flammable surface away from flammable materials until completely cool.
cleaning the glass
Cleaning the glass should be done when the fireplace is warm. On the market there are many cleaning solvents to remove
debris. Refer to the owner's manual. Do not use abrasive cleaners. The door is always closed with a handle.
cleaning the chimney
When wood burns slowly is formed a black carbon containing organic substances which react with water vapor that is emitted
by the wood, thereby, the walls of the chimney when cold precipitate forms creosote. If the sediment is formed flame lights up with
a very high temperature. Regularly check the build-up of creosote on it to determine the frequency of cleaning the chimney. Please
note that the combustion is more intense the build-up of creosote is less.
8. Glass installation instructions
The glass in the frame should not be too tight. After installation must be possible to move the glass in the frame. This is
necessary because the glass and metal have different coefficients of thermal expansion and too tightly attached window has been
destroyed.
!
The maximal temperature of the continuous heating is about 800 ° C. The average temperature in the fireplace operates on
the glass is about 450 ° C. This leaves a very large available reserves and crack windows can not be caused by overheating

9. chimney fire

Too infrequent cleaning of the chimney or burning of wet wood, may result in chimney fire caused by inflammation of creosote
(inflammable substance emitted when wet wood is burned). Distinctive symptoms of the chimney fire are: smell of the flue gas (soot)
in the building, alarming, previously unheard sounds in the chimney, a large increase of the chimney temperature, sparks or flames
coming out from the chimney.
in case of the chimney fire, you must:
• immediately call the Fire Brigade
• extinguish the fire in the fireplace as much as possible, using sand or soil
• do not extinguish the fire with water, since the rapid cooling of the chimney and evaporation of water can cause cracks and
spread of the fire
• cut off the chimney air supply – close the door, close the primary air intake and secondary air intake (if possible)
• Once the fire is extinguished, chimney sweep company should carry out an inspection of chimney technical condition,
before you light the fire in the fireplace again.
10. troubleshooting
Symptoms probable cause
Issue with setting Too much moisture in wood
a fire. Flame
extinguishes.
Too thick wood logs
No air supply
Insufficient chimney air draft
46
to MoUnt GLaSS do not USe any perManent adheSiVe bindinG
GLaSS and MetaL. GLaSS iS not Under warranty
actions
Use wood that moisture content not exceeds 20% (seasoned wood for 2
years in a covered and well-ventilated place).
When setting a fire, use small pieces of wood. To maintain the fire use
splintered logs.
Increase air supply by opening the air intake diaphragm.
Check if the flue gas damper is not closed (open in case it is closed).
Arrange an inspection of chimney flue to check if there is no leakage or if
the flue is not clogged (clean if needed).
www.kawmet.pl