Y-Volution YVelo Junior Bedienungsanleitung Seite 10

About the YVelo Junior
This Y Velo Junior balance bike allows your
child to practice the basic skills of locomotion
and balance, helping them to master the skills
of walking and running. This will allow your
child to move on to cycling bikes, without the
use of out-dated stabilisers. The skills your
child learns on the Y Velo will also improve
their self-efficacy and give them ample social
interaction opportunities. Playing on their Y
Velo will also contribute to their daily physical
activity recommendations.
WARNING!
1. Adult assembly required
2. Before riding, please check that all fasten-
ers are correctly secure.
3. Always wear shoes when riding.
4. For the child's personal safety, always use
safety equipment such as Helmet, Elbow
pads, Knee Pads, and Gloves.
5. To be used on smooth paved surfaces and
away from traffic. Not for use on public roads.
6. Not to be used at dusk, at night, or at
times of limited visibility and unfit weather.
7. Replace worn or broken parts immediately.
8. Only one rider at a time.
9. Maximum weight is 20 kgs.
10. Suitable for children between 18 months
and 4 years old.
------------------------------------------------------
1 Rear Wheel Assembly
The YVelo Junior Balance bike is designed to
have two settings for the back wheel:
Option A
Double Rear wheels for extra balance to get
you started
Option B
Single wheel setting for more advanced rid-
ers.
A. Double Rear Wheel
A1
Screw the Plastic Rear Wheel Separator
(no.18) into the Frame's receiver (no.13) us-
ing the Screw (no.16) and the 4mm Hex Key
(no.15). Place two rear wheels (no.2) into the
10
rear wheel fork (no.1), with one Short Rear
Wheel Spacer (no.17) on each side so that the
wheel sits comfortably between them.
A2
Then slide the Rear Wheel Axle (no.9)
through the centre of the axle and wheels.
Finally, fasten the axle in place using the Bolt
(no.10) and the two 5mm Hex Keys (no.14).
B. Single Rear Wheel
B1
Place rear wheel (no.2) into the rear wheel
fork of the Frame (no.1), with one Long Rear
Wheel Spacer (no.13) on each side so that the
wheel sits comfortably between them. Then
slide the Rear Wheel Axle (no.9) through the
centre of the axle and wheel. Finally, fasten
the axle in place using the Bolt (no.10) and
the two 5mm Hex Keys (no.14).
2. Front Wheel Assembly
EN
Slide the Front Fork (no.3) through the front
of the Frame (no.1), and place the Stem Cap
(no.8) on top of the Front Fork.
Then slide the Handle Bar (no.5) down
through the Stem Clamp (no.8). Lock the
Handle Bar into the appropriate place using
the Dome Headed Bolt (no.10) and Allen
Headed Receiver Nut (no.11).
3. Seat Assembly
Put the Seat (no4) into the Frame ( no1 ) and
lock at the appropriate height with the Seat
Adjustment Knob (no.6) and Seat Nuts (no.7)
4. Your Balance bike should now be complete.