Operation - HANSGROHE Punto 14060000 Montageanleitung

Assembly
The fitting must be installed, flushed and
tested after the valid norms!
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation valves;
cold right - hot left.
5. Connect the pull rod to the pop-up waste.
The hot and cold water supply's should be of equal
pressures.

Operation

The mixer is activated by lifting the lever handle.
Move to the left = hot water,
move to the right = cold water.
Technical Data
This mixer series-produced with waterdim-
mer (flow limiter)
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
bars
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
If the continuous water heater causes any problems
or there is not enough flow of water, the waterdimmer
(5a) located behind the aerator must be removed.
To adjust the hot water limiter on single lever mixers,
please see page 13.
No adjustment is necessary when using a continuous
flow water heater.
6
English
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
Special accessories
X
7 l/min 3 bars
14 l/min 3
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
65° C
handle
flange
nut
cartridge cpl.
aerator cpl. (10)
pop up rod
fixing set
connection hose
special tool set
(not part of delivery)
96602000
96338000
94192000
94194000
92730000
13085000
92620000
96016000
97206000
58085000