Proceed as follows to insert a cutting insert 3 4 5:
♦
Insert the selected cutting insert 3 4 5 from above into the opening of the
motor unit 6 . Note the appropriate recesses in the drive ring .
♦
Now, place the feed tube 2 from above onto the opening of the motor
unit 6 so that the catches on the feed tube 2 lie in the recesses on the
motor unit 6 . One of the arrows ▼ on the feed tube 2 must point to the
symbol on the motor unit 6 .
♦
Now, turn the feed tube 2 anticlockwise as far as it will go . Once the ▼
arrow on the feed tube 2 points to the
feed tube 2 is correctly closed . The feed tube 2 clicks audibly into place .
■
24
│
GB │ IE
symbol on the motor unit 6, the
SSSE 300 A1