Temperature Limitation; Maintenance - Hansgrohe Axor Starck 10720 Serie Montageanleitung

Assembly
Attention! The fitting must be installed, flushed and
tested after the valid norms!
Adjustment
Correction is necessary if the temperature measured
at the take off point differs from the temperature
set on the scale. To adjust temperature proceed as
follows:
Turn the setting knob until water at a temperature
of 38° C comes out of the outlet. Loosen screw of
setting knob. Remove setting knob and turn to the
38° C position. Attach setting knob again and
tighten the screw.

Temperature limitation

The temperature is limited by the safety check to 38°
C (100° F). If a higher temperature is required, it is
possible to override the safety stop by depressing
the safety button.
Safety Function
The desired maximum temperature for example max.
42° C can be pre-set thanks to the safety function
(please see page 24).
Technical Data
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.: 65° C
Rate of flow by 0,3 MPa

Maintenance

There is no special maintenance for thermostats. The
non return valves () must be checked regularly
according to DIN EN 1717 in accordance with nati-
onal or regional regulations (at least once a year). At
this time, please also check the filter (1.1) situated
on the MTC-thermo-element (1). After assembling
the MTC-thermo-element, it is necessary to check
the water temperature at the take off point as de-
scribed under the headline „adjustment". Before the
adjustment, please check, if the warm water supply
is activated and the maximum temperature of the
warm water is available at the take off point.
10
English
max. 1 MPa
1,6 MPa
max. 80° C
approx. 26 l/min
To guarantee the smooth running of the thermostat, it
is necessary from time to time to turn the thermostat
from total hot to total cold.
Spare parts (see page 3)
1 handle for thermostat Starck
2 handle for thermostat Carlton „lever" 17391XXX
3 handle for thermostat Carlton „cross" 17994XXX
4 handle for thermostat Steel
5 handle for thermostat Allegroh
6 handle for thermostat Terrano „lever" 37391XXX
7 handle for thermostat Terrano „cross" 37994XXX
8 handle for thermostat
Uno/Citterio M
9 handle for thermostat Montreux
10 screw cover for cold / hot water 97987000
11 handle for thermostat Citterio „lever" 39994XXX
12 handle for thermostat Citterio „cross" 39391XXX
13 handle for thermostat Massaud
14 face plate Massaud
15 face plate
16 face plate Citterio cpl.
17 face plate Starck X
18 face plate Montreux
19 face plate Citterio M
20 sleeve
21 thermostat cartridge
22 noise reduction
23 non return valve
24 shut off unit with selector
25 sub plate
26 fixing screw
27 sleeve
28 handle Starck/Citterio
Massaud/Citterio M
29 handle Uno/Terrano/Steel
30 handle Carlton/Allegroh
31 handle Montreux
32 extension set 25 mm
33 extension set 22 mm
34 extension set 22 mm
Citterio / Starck X
35 extension set 22 mm Citterio M
36 adapter for handle
37 adapter for handle
38 sleeve Massaud
39 adapter for handle Massaud
10391XXX
35391800
36391XXX
38391XXX
16594XXX
18097000
98688000
96551XXX
96751XXX
97926000
98638XXX
98919000
96439XXX
94282000
94073000
94074000
96509000
96447000
96454000
96446XXX
96520XXX
96421XXX
96449XXX
98637XXX
13595000
13596XXX
97407XXX
98860000
96435000
96451000
98734000
98701000