Troubleshooting; The Hydromassage Does Not Activate; The Hydromassage Stops Of Its Own Accord; Not Many Air Bubbles Come Out Of The Larger Hydromassage Outlets - Jacuzzi maxima Bedienung Und Wartung

Troubleshooting...

The hydromassage does not activate

The hydromassage stops of its own accord

Not many air bubbles come out of the
larger hydromassage outlets
The "strength" of the hydromassage has
got weaker

The Sanitization cycle does not activate

The Sanitization cycle stops of its own ac-
cord
The display does not receive commands
main switch is off
command not accepted
the water level is not adequate (an acous-
tic signal sounds when an attempt is made
to activate the function)
the water level is not adequate (an acous-
tic signal sounds when an attempt is made
to activate the function)
the outlet nozzles are closed
air regulators set to the minimum
the outlet nozzles are closed
air regulators set to the minimum
air and/or whirlpool outlets are blocked
the water level is not adequate ((an acous-
tic signal sounds when an attempt is made
to activate the function)
a lack of liquid (J-MX 07) in the tank (an
acoustic signal sounds when an attempt is
made to activate the function)
the water level is not adequate (an intermit-
tent acoustic signal sounds)
If two keys are accidentally pressed at the
same time, no function is activated
If the display is covered by a layer of water,
it may not receive commands
21
turn on the main switch
press down the button for a few seconds
and then release it
fill the tub to the level indicated (refer to
the Chapter, "Filling the tub") and press
the button once again
fill the tub to the level indicated (refer to
the Chapter, "Filling the tub") and press
the button once again
open the nozzles (refer to the Chapter,
"Recommendations")
activate the air regulators (refer to the
Chapter, "Recommendations"
open the nozzles (refer to the Chapter,
"Recommendations")
activate the air regulators (refer to the
Chapter, "Recommendations"
clean the outlets as described in the
Chapter "Maintenance"; where this is not
sufficient, contact a Jacuzzi® Support
Centre
please refer to the details provided for
the hydromassage
refill the tank within one minute from
notification (the pumps will activate and
the function continues); where this is not
completed, the function is definitely in-
terrupted
restore the water level within 5 minutes
from notification (the pumps will activate
and the function continues); where this is
not completed, the function is definitely
interrupted
You will need to wait three seconds befo-
re giving a new command
Just wipe the water off with the palm of
your hand and wait about 3 seconds be-
fore giving another command