Grilling With Closed Lid - Patton bbQ sunny 2+burner Gebrauchsanweisung

cleaning sponge for stainless steel with cleaning agent should be applied.
SPIDERS AND OTHER INSECTS CAN BUILD SPIDER-WEBS OR NESTS IN THE BURNERS (AND HIS BORINGS)
AND HOSES AND CAN DECREASE THE DAS FLOW OR CAUSE A FIRE.
THIS EFFECT WAS NAMED AS „REVERSE FLOW" AND CAN SERIOUSLY DAMAGE THE GRILL OR CAUSE
A DANGEROUS FIRE. A CLEANING OF THE BURNERS (HIS OPENINGS), HOSES AND CONDUCTORS
using tHe burners and ligHting prOcedure cOntrOl
Open tHe lid beFOre ligHting yOur grill
1. Turn all the control knobs to the 'OFF' position and open the gas bottle valve.
2. If the grill is installed for the first time, then the gas hoses are filled with air. Some time is necessary to fill the hoses with gas.
3. Push the operating switch and turn it into the highest position „HI". Simultaneously push the electric spark igniter.
Release the igniter when the burner light up. If the grill has the igniters build in the hand regulator, light the burner
turning the switch (operating switch).
4. If the burner was not lit after two attempts, turn 'OFF' the gas tap on the gas bottle and retry the ignition sequence to
step 3, 2 - 3 times.
5. If the burner still will not switched on, go to step 4, IN SUCH A CASE TURN OFF THE GAS AND WAIT 5 MINUTES,
after this try to light the burner using normal matches.
6. Attention: Before every check turn the operating switches to the „OFF" position.
7. If the burners still will not be switched on, close the gas botle valve and check the gas conductors if they are not clogged.
First using aFter a lOnger periOd – beginning OF tHe seasOn
● Carefully read the safety, lighting and operating instructions.
● Check the gas supply openings, gas conductors, gas hoses, burners conductors and the burners, if they are not clogged.
● Check if the burner conductor is property guided through the closing opening.
● Check if the gas bottle is filled.
● Check that no gas gas leakages exist, to do this use a soap solution.
● Turn the operating switch to „OFF" position and close the gas supply.
● Before you light the grill, open the grill lid.
Operating tHe side burner
● Before you light the gas, check if the gas hose has no cracks, break, damages or wearings. If yes- replace the gas
hose before using the grill. The side burner cannot be used if you feel a gas smell.
● Not far away from the gas valve place a sprayer with a soap- water solution and before using, check the connections.
● Before you will light the grill, open the lid.
● Push the hand regulator (switch) and turn it into the highest position „HI". Simultaneously push the electric spark
igniter. Release the igniter when the burner light up. If the grill has the igniters build in the operating switch, light the
burner, turning the switch.
●
If the burner still will not switched on, try to light the burner using normal matches.
● Use pans with a minimal diameter 120 mm and maximum 200 mm. When using pans with grater diameters,
the highest layer can change his color.
First use, burning Out tHe Fat Or Oil
Before the first use, the fat and oil used to protect the grill should be burned out.
● Open the lid, light the burners and burn on the highest fire "HI" through 10- 15 minutes.
● Close the switches, cool down, and clean the grill with a cleaning agent - water solution using a scrubbing sponge.
Next properly dry the unit.

grilling WitH clOsed lid

urgent: When you are cooking with the lid closed, never set all burners in the „Hi" position
GB, E
IS RECOMMENDED IN REGULAR INTERVALS.
21