Ingersoll-Rand 212 Gebrauchsanweisung Seite 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
POWER REGULATOR
Model 212 Impact Wrench is equipped with a
combination power regulator/reverse valve designed to
provide power adjustment in the forward direction while
maintaining full power in the reverse direction. The
power output is calibrated by stamped numbers "1"
through "5".
SETTING THE POWER REGULATOR
Power Adjustment for Model 212
The Model 212 Impact Wrench incorporates a power
regulator into the reverse mechanism that allows the
operator to have either full power output in one direction
and reduced power output in the other direction or full
power output in both directions. To adjust the power,
proceed as follows:
For full power in both directions, rotate the Reverse
Valve (25) until the notch on each end of the Reverse
Valve aligns with the number 5 on each side of the
housing.
The numbers 1 thru 5 on the
housing are only for reference
and DO NOT denote a specific
power output. One (1)
designates the lowest power
output while five (5) denotes
the highest.
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by the
hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pres-
sure.
ADJUSTMENTS
(Dwg. TPD1247)
WARNING
WARNING
WARNING
For reduced power in the forward direction and full
power in the reverse direction, push the reverse valve
inward on the right side of the tool and rotate the reverse
valve until the notch on the right side aligns with the
desired number on the right side. This provides reduced
power in forward but full power in reverse when the
reverse valve is pushed in the opposite direction.
See Dwg. TPD1248.
For reduced power in the reverse direction and full
power in the forward direction, push the reverse valve
inward on the left side of the tool and rotate the reverse
valve until the notch on the left side aligns with the
desired number on the left side. This provides full power
in forward but reduced power in reverse when the reverse
valve is pushed the opposite direction.
See Dwg. TPD1249.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
(Dwg. TPD1248)
(Dwg. TPD1249)