Dell Precision WorkStation 530 Handbuch Seite 15

If the memory total is incorrect, repeat step 1 through step 3. Check
14
the installed modules and riser boards to ensure that they are seated
properly in their sockets. Then repeat step 10 through step 13.
When the System Memory total is correct, exit system setup.
15
NOTE: For more information about system setup see your
Turn off the computer, and attach the devices to the computer and
16
electrical outlets.
Removing a Memory Module
CAUTION: B ef or e you p e r fo rm t hi s pr oc e d ur e , s e e
" Pr ec a u ti on a r y M e a su r es . "
NOTICE: To avoid damage to the memory module, press the securing clips
with equal force applied at each end of the memory socket.
Press the securing clips at each end of the memory socket outward
1
simultaneously until the module pops out slightly from the socket (see
the following figure).
NOTE: To access the securing clips on the system board memory sockets,
it may be necessary to remove the fan for microprocessor 0. For
instructions on removing and installing the processor fan, see the
Service Manual .
Lift the module away from the socket.
2
R e m o v i n g a M e m o r y M o d u l e
securing clips (2)
memory socket
User's Guide .
M e mo r y R i s er B o a rd Re p la c e m en t
15