V2 DRYS270 Handbuch Seite 16

FIXING THE ACTUATORS
1. Attach the rear attachment on the pillar by following the
instructions on the table on the next page, adjust the length
of the supplied attachment if necessary.
The respect of the dimensions indicated in the tables ensures
the proper operation of the automation.
In the case of an iron pillar, carefully weld the rear attachment
directly onto the pillar.
In the case of a masonry pillar opt for one of the following
solutions:
- Carefully install a wall plate and then weld the rear
attachment;
- Attach the rear attachment plate to the pillar with screws
and dowels and weld the rear attachment onto the plate
2. Attach the actuator to the rear attachment (Fig. 1);
3. Half tighten the screw of the front attachment (swivel head)
on the stem and tighten with the supplied nut (fig. 2);
4. Release the actuator;
5. Pull out the chrome stem as far as it will go;
6. Reblock the actuator;
7. Mount the front attachment on the stem (Fig. 3);
8. Close the gate leaf and, keeping the actuator perfectly
horizontal, locate the front attachment position on the leaf
(Fig. 4);
9. Temporarily attach the front attachment to the gate leaf by
means of two welding points; protect the stem from any
welding slag
10. Release the actuator, manually check that the gate is free to
open and stop on the pre-installed end-of-stroke mechanical
stops; also check that the gate leaf movement is smooth and
free of friction;
11. Momentarily disconnect the actuator from the attachment and
permanently weld the front attachment on the leaf (Fig. 5)
12. Re-attach the stem to the front attachment and apply the
stem cover to the actuator
13. Reblock the actuator and carry out the electrical connections
with the electronic equipment, according to the instructions
given in the relevant manual.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
- 14 -