Replacing Lamps - Cata K-600/A Inox Gebrauchsanleitung

Care and maintenance
If one of the lamps no longer functions, the bulb must be replaced. You require a

Replacing lamps

bulb with an E 14 screw base, 230 V, max. 40 Watt.
The appliance operates using a hazardous voltage. Before replacing
Electrical shock hazard!
the bulb, disconnect the mains plug. Do not touch any live components
inside the socket.
Before opening the cover and removing the bulb, allow the bulb to
Risk of burns!
cool down.
Do not touch the new bulb with your fingers, because this will reduce
Important!
the service life. Use a dry cloth.
1. Pull the plug out or disconnect the power supply using the recently installed
switch (see "Accessibility of power supply", page 9).
2. Push the lock on the grease filter backwards and remove the grease filter
carefully downwards.
Grease �ilters
3. Allow the lamp to cool sufficiently. Screw the defective lamp from its
receptacle and replace it with a lamp of the same type.
4. Reinsert the grease filter in the rear recesses.
5. Push the lock downwards and press the grease filter into the holder. Release
the lock and the grease filter clicks into place.
6. Restore the power supply.
General
19
English