Electrolux FI22/12NV Benutzerinformation Seite 13

Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The door is not closed
correctly or the gasket is
deformed/dirty.
Appliance is fully loaded
and it is set to the lowest
temperature
Temperature set in the
appliance is too low and
the ambient temperature
is too high.
This is normal, no error
has occurred.
Food products prevent
the water to flow into the
water collector.
The water outlet is clog‐
ged.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The "FastFreeze func‐
tion" is switched on.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
ENGLISH
Solution
Refer to "Closing the door".
Set a higher temperature.
Refer to "Operation".
Set a higher temperature.
Refer to "Operation"
The compressor starts after
a period of time.
Make sure that food prod‐
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water out‐
let to the evaporative tray.
Switch off "FastFreeze func‐
tion" manually, or wait until
the function resets automati‐
cally to set the temperature.
Refer to "FastFreeze func‐
tion".
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Add less food products at
the same time.
Open the door only if neces‐
sary.
13