Herunterladen Inhalt Inhalt Diese Seite drucken

Removing The Rechargeable Battery; Guarantee And Support; Guarantee Restrictions - Philips PT937 Handbuch

Vorschau ausblenden Andere Handbücher für PT937:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 37
Problem
Possible cause
The shaver does
The shaving heads are damaged
not shave as well
or worn.
as it used to.
Long hairs obstruct the shaving
heads.
You have not inserted the
shaving heads properly.
The shaver does
The rechargeable battery is
not work when I
empty.
press the on/off
button.
The temperature of the shaver is
too high. In this case, the shaver
does not work.

Removing the rechargeable battery

Note: We strongly advise you to have a professional remove the rechargeable
battery.
Only remove the rechargeable battery when you discard the shaver.
Make sure the battery is completely empty when you remove it.
1
Check if there are screws in the back of the shaver or in the hair
chamber. If so, remove them.
2
Remove the back and/or front panel of the appliance with a
screwdriver. If necessary, also remove additional screws and/or parts
until you see the printed circuit board with the rechargeable battery.
3
Remove the rechargeable battery.

Guarantee and support

If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaflet.

Guarantee restrictions

The shaving heads (cutters and guards) are not covered by the terms of
the international guarantee because they are subject to wear.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Centre in your
country.
Solution
Replace the shaving heads (see chapter
'Replacement').
Clean the shaving heads one by one (see
section 'Cleaning the shaving unit under the tap'
in chapter 'Cleaning and maintenance').
Make sure that the projections of the shaving
heads fit exactly into the recesses (see section
'Cleaning and maintenance').
Recharge the battery (see chapter 'Charging')
or connect the shaver to the mains.
As soon as the temperature of the shaver has
dropped sufficiently, you can switch on the
shaver again.
ENGLISH
19

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis