Kenwood DF520 Serie Bedienungsanleitung Seite 5

know your Kenwood deep fryer
safety
G
Never plug in the fryer before filling the bowl with oil.
G
Keep children away during use and after - fat stays hot
for a long time.
G
Never let the cord touch hot surfaces or hang down
over the worktop edge - a child could grab it and pull
the fryer down. Place excess cord in cord storage area
at the back of the fryer.
G
Never touch the bowl, pour away oil or move your fryer
while the oil's hot.
G
Never put the electrics unit in water. Remove it before
washing the rest of your fryer.
G
After cleaning, ensure the bowl and its electric pins are
dry before use.
G
Never leave your fryer on unattended.
G
This fryer is not intended for use by young children or
infirm persons without supervision.
G
Young children should be supervised to ensure that
they do not play with this appliance.
G
Take care when removing the electrics unit - the
temperature probes may be hot.
G
Do not use if there is any damage to the fryer, cord or
plug. Get it checked or repaired: see 'service'.
G
Only use the electrics unit supplied.
G
Watch out for steam during cooking and when you
open the lid.
G
Never put your fryer near or on cooker hot plates.
G
This fryer is for domestic use only.
G
Always unplug the fryer after use.
before plugging in
G
Make sure your electricity supply is the same as the
one shown on the underside of the electrics unit.
G
This machine complies with European Economic
Community Directive 89/336/EEC.
before using for the first time
1 Remove all packaging.
2 Dismantle: see 'to dismantle, assemble and use your
fryer'.
3 Wash the parts: see 'cleaning'.
know your Kenwood fryer
removable lid with permanent mesh filter
viewing window
lid seal
condensation trap
rise and fall control
pouring lips
removable bowl
lid release
carrying handles
electrics unit
timer
temperature control with neon light
temperature probes
cord storage
to dismantle, assemble and use
your fryer
to dismantle
1 Push the lid release
the lid off.
2 Lift up the handle and remove the basket.
3 Pull out the electrics unit and then remove the bowl.
G
Before removing the electrics unit check that
the cord is released from the cord storage
area at the back of the fryer
to assemble and use
1 Insert the bowl – 'MAX' and 'MIN' marks to the back of
the fryer.
2 Then insert the electrics unit
the fryer +
3 Pour in the oil. The level must be between the 'MAX'
and 'MIN' marks
4 Insert the basket and close the lid. Then lower the
handle by sliding back the rise & fall control
5 Plug in and select the required temperature
6 The light goes out when the oil reaches the right
temperature to start frying. Fill the basket and lower
into the oil . Don't exceed the maximum food
quantities stated. The light will come on and off as
the fryer maintains the temperature.
2
down to open the lid. Then lift
.
– cord to the back of
.
.
.
.