General Safety Instructions; Special Safety Instructions For This Machine; Overview Of The Components; Instruction Manual - Clatronic ae 3150 Bedienungsanleitung

General Safety Instructions

Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing. If you give this device to other people, please also pass
on the operating instructions.
• The appliance is designed exclusively for private use and for
the envisaged purpose. This appliance is not fit for commer-
cial use. Do not use it outdoors. Keep it away from sources
of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands.
If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance
and always pull out the plug from the socket (pull the plug
itself, not the lead) if the appliance is not being used and
remove the attached accessories.
• Do not operate the machine without supervision. If you
leave the room you should always turn the device off.
Remove the plug from the socket.
• The device and the mains lead have to be checked regularly
for signs of damage. If damage is found the device must not
be used.
• Do not try to repair the appliance on your own. Always
contact an authorized technician. To avoid the exposure
to danger, always have a faulty cable be replaced only by
the manufacturer, by our customer service or by a qualified
person and with a cable of the same type.
• Use only original spare parts.
• Pay careful attention to the following "Special Safety Instruc-
tions".
Children and Frail Individuals
• In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
WARNING!
Caution! Do not allow small children to play with the foil
as there is a danger of suffocation!
• This device is not intended to be used by individuals (includ-
ing children) who have restricted physical, sensory or mental
abilities and/or insufficient knowledge and/or experience, un-
less they are supervised by an individual who is responsible
for their safety or have received instructions on how to use
the device.
• Children should be supervised at all times in order to ensure
that they do not play with the device.
Symbols in these Instructions for Use
Important information for your safety is specially marked. It is
essential to comply with these instructions in order to avoid ac-
cidents and prevent damage to the machine:
WARNING:
This warns you of dangers to your health and indicates
possible injury risks.
24
05_AE 3150 Neu.indd 24
CAUTION:
This refers to possible hazards to the machine or other
objects.

NOTE: This highlights tips and information.

Special Safety Instructions for this Machine

WARNING:
Do not use the device if the rotating filter is damaged.
1. The machine should only be used under supervision!
2. Do not manipulate any of the safety switches!
3. Before removing any covers or accessories, switch the
device off and wait until the motor has stopped.
4. Please take care when handling the centrifuge sieve. It is
very sharp!
5. The machine may only be switched on when the stopper rod
is inserted.
6. Do not carry or lift the appliance during use. Always switch
it off first and pull out the plug. Carry the appliance always
with both hands!
7. Clean the appliance only as described in „Cleaning".

Overview of the Components

1 Tamper
2 Cover / Filling hole
3 Centrifuge sieve
4 Centrifuge housing
5 Drive wheel
6 Motor housing
7 Safety lock
8 Multiple contact switch
9 Pomace container
10 Safety switch
11 Spout
12 Rubber feet
Operation
1. Place the machine on a smooth, flat and stable working
surface. Please place the centrifuge housing on the motor
block in such a way that the spout lies flush in the recess.
Place the centrifugal screen (3) in the centrifuge housing (4).
2. Place the cover in position and lock the safety catch. The
locking devices must engage in the recesses of the cover.

NOTE:
Your device is fitted with a safety switch (10). This pre-
vents the motor from starting accidentally. Check that the
centrifuge filter and cover are correctly positioned.
3. Hook the pulp container (9) under the cover (2) such that it
is flush.
4. Please ensure that the multiple contact switch is set to „O".
5. Connect the machine to a properly installed power socket,
230 V, 50 Hz.
6. Place a suitable vessel under the spout (11) of the centrifuge
housing.
18.07.11 09:40