Keep-Warm Function; Automatic Shutoff - WMF SKYLINE Gebrauchsanweisung

Keep-warm function

Set the desired temperature by pressing the respective button. Then
press the keep-warm button . This will now glow blue and the
water begins to be heated.
A signal tone will beep once the desired temperature has been reached.
The water is then kept at the desired temperature until you remove
the kettle from the base to pour out water. If you leave the kettle
on the base, it will automatically switch back to standby mode after
approximately 20 minutes.

Automatic shutoff

The device switches to standby mode shortly after the selected
temperature is reached. The shutoff time is extended if the pot is only
filled with a little water.
The shutdown takes place automatically if the pot is lifted from the
base.
For functional reasons, some condensation may run out of the outlet
openings at the bottom of the handle to the edge of the base. This
happens for technical reasons and does not impair the safety of the
device.
Safety system
A thermostat protects the kettle from overheating due to accidental
operation without water by switching off the device.
It is essential to allow the pot to cool down before filling with water.
Should the first thermostat malfunction due to improper use, an
additional temperature limiter ensures reliable protection.
Cleaning and maintenance
Remove the mains plug and allow the device to cool down. Do not
immerse the device and base in water, but rather clean them with a
damp cloth with a little washing-up fluid and then dry off.
Do not use any sharp and abrasive cleaning agents.
The pot is made of stainless steel. Should rust spots nevertheless
appear, they are only deposits adhered to the surface. They should be
removed immediately with a stainless steel cleanser.
The strainer insert in the pour spout can be removed for cleaning when
the lid is open. To do so, pull its clip upward. When inserting, place the
strainer in the middle and then snap it forward into place.
11