WMF SKYLINE Gebrauchsanweisung Seite 10

Start-up
Thoroughly clean the inside of the pot prior to the first use. To do so,
open the lid by pressing the button on the handle.
A strainer insert in the pour spout ensures that larger limescale parti-
cles are kept back when pouring.
The unnecessary length of the connecting cable can be wound at the
bottom of the base part.
Connect the mains plug to an earthed socket.
Fill with at least 0.5 litres of water, but at the most up to the Max -
marking. Close the lid.
Place the pot on the base in any position. To complete the start-up,
boil a maximum capacity of water, which you should not use for food
preparation.
Standby
After connecting the mains plug, the start / stop and 100°C buttons
will illuminate white and the device is in standby mode. After 15
minutes of inactivity, the electric kettle switches off, the control lamps
go out and the power consumption is then less than 0.5 watts.
In order put the device back on standby, press the start / stop but-
ton.
Boil the water
Place the filled kettle on the base. The device is in standby mode and
the pre-selection temperature 100°C illuminates.
Press the start / stop button . This will now glow blue and the water
begins to be heated. As soon as the water is boiling, a signal tone will
beep and the device automatically switches to standby mode.
You can interrupt the boiling process at any time by pressing the start
/ stop button again.
In order to switch off the kettle, hold down the start / stop button
for approximately 3 seconds and the control lights will go out.
Temperature pre-selection
The kettle gives you the possibility of heating water to a desired
temperature, e.g. one that matches your favourite type of tea: 70°C for
fine green tea types or 90°C for Oolong tea or white tea. Observe the
respective manufacturer's specifications.
Place the filled kettle on the base and the device is in standby mode.
Set the desired temperature (60, 70, 80 or 90°C) by pressing the
respective button. Then press the start / stop button . This will now
glow blue and the water begins to be heated.
A signal tone will beep once the desired temperature has been reached.
Please understand that for technical reasons the temperature may
differ a few degrees from the set temperature.
10