Warnings For The User - GiBiDi SR100 Installationsanleitung

10
UK
• Mark the automated gate with visible warning plates.
• Warn the user that children and animals may not play or stand around near the gate.
• Appropriately protect the dangerous points (for example, use a sensitive frame).

WARNINGS FOR THE USER

In the event of an operating fault or failure, cut the power upstream of the control unit and call Technical Service.
Periodically check functioning of the safety devices. Any repairs must be carried out by specialised personnel using
original and certified materials.
The product is not to be used by children or people with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction. Do not intervene on the board for
regulations and/or maintenance.
WARNING: IMPORTANT SAFETY INSTRUCTIONS
For people's safety, it is important to follow these instructions.
Please keep this manual.
ELECTRICAL CONNECTIONS: TERMINALBOARDS
Terminal Position
M1
M2
M3
M4
J3
Connector for connexion to the programmer PRG_01
Signal
1
N
2
L
3
EARTH
4
EARTH
5
LAMP
6
LAMP
7
OPEN
8
COM
9
CLOSE
10
24VDC
11
GND
12
G_OP
13
G_CL
14
START
15
PHOTO
16
SAF
17
+ ANT
18
- ANT
Description
Neutral power supply 230 Vac
Power supply phase 230 Vac
Ground connection
Ground connection
Flashing light output 230Vac 25W
Flashing light output 230Vac 25W
Motor connection (opening)
Common motor
Motor connection (closing)
External accessories 24 Vdc power supply
External accessories power supply. Common Inputs – Outputs
Input GENERAL OPEN (N.O.)
Input GENERAL_CLOSE (N.O.)
Input START (N.O.)
Input PHOTOCELL (N.C.). Active only during closing.
Input SAFETY DEVICES. See DIP 9-10
Input ANTENNA SIGNAL
Input ANTENNA BRAID
SR100
Fixed output to be used for
flashing light with flashing circuit